This washer and dryer established has been all around for some time now, the 3000 series could be nearly 12 years previous.
Accessing the washer’s primary parts is mostly done from the entrance, to take away the again is simple, I will explain “How To” at the conclude of this article.
The first step in accessing your washer is to remove the screws around the doorway body. There are two screws situated on the doorway hinge and two straight reverse. These 4 screws will need to have to be taken out to acquire obtain into the inside of the washer.
With the entrance off the washer, the drain pump, motor control board and many other parts will be obvious and obtainable. The motor control on the right is acknowledged for going out, if your washer stopped spinning, presents an LR mistake code, this motor manage is the very likely culprit. Cleansing the pump can be carried out from the front or the back again, the again panel is held tight with 4 screws. The only trick to getting the back again panel again on is to snap the plastic onto the steel prior to the panel is mounted.
If you are one of the unfortunate types working with the wax motor control board malfunction, you are not alone, the top of the washer will want to be lifted in get to gain obtain.
To do so the 4 screws beneath the cleaning soap dispenser will need to have to be taken off, these are the screws the arrows are pointing to in the photograph on leading of the washer.
In get for appliance repair orange county carry cost-free the two corner brackets will require to be removed, if you have previously removed the screws all around the door body and the entrance is off you will see the two brackets that keep the top down, 1 5/sixteen screw holds every bracket.
With the four screws eliminated from the cleaning soap cup housing and the two steel clips, the leading will elevate up.